Make sure you work with your reseller if you are looking to deploy these features. This document will help you make sense of ASA licensing, but is not intended to be used as a design guide. The matters are further complicated since different appliances and versions change the rules. Route outside 0.0.0.0 0.0.0.0 24. ASA firewall licensing used to be pretty simple, but as features were rolled out as licenses, the scheme became quite complex. Icmp unreachable rate-limit 1 burst-size 1

IPSec microcode : CNlite-MC-IPSECm-MAIN-2.05Ġ: Ext: Ethernet0/0 : address is 996, irq 9ġ: Ext: Ethernet0/1 : address is 997, irq 9Ģ: Ext: Ethernet0/2 : address is 998, irq 9ģ: Ext: Ethernet0/3 : address is 999, irq 9Ĥ: Ext: Management0/0 : address is 99a, irq 11ĥ: Int: Internal-Data0/0 : address is 0000.0001.0002, irq 11Ħ: Int: Internal-Control0/0 : address is 0000.0001.0001, irq 5Įnable password 8Ry2YjIyt7RRXU24 encrypted SSL/IKE microcode: CNLite-MC-SSLm-PLUS-2.03 Hardware: ASA5510, 1024 MB RAM, CPU Pentium 4 Celeron 1600 MHzĮncryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0) System image file is 'disk0:/asa804-k8.bin' NAT should be the last part in getting access to the internet, correct?Ĭisco Adaptive Security Appliance Software Version 8.0(4)Ĭompiled on Thu 07-Aug-08 20:53 by builders I would greatly appreciate it.Įthernet 0/0 is plugged into my modem which is assign a DHCP IP, the default route is the gateway I grabbed from my ISP. I need some help configuring NAT so I can access the internet. Just going back to basic setup simply want internet access from behind the ASA inside network. So the NAT config didn't take, here is what I have. I will update ASA tonight and post results.

Nat (Inside,Outside) after-auto source dynamic STAN_PAT interface Thanks Paul, so here is what I have, just to be sure I have updated it correctly. Thanks for your time, I look forward to hearing back from anyone.

Username XXXXXXX password XXXXXXXXX privilege 15 I was wondering if someone could look over this config and see if anything is missing for a simple basic setup? Just need the routers to access the internet (ISP uses DHCP, no static address)Īlso attached a diagram of my network layout.

Simple cisco vpn setup on asa5510